Skim coats
CERESIT IN 35
START + FINISH
Gypsum-based rendering skim coat for filling defects on wall and ceiling surfaces for skimming surfaces finished with paint coats and wallpapers and for joining plasterboards with tape.
-
Machine application possible
-
Easy to grind
-
Layer thickness up to 10 mm
- Description
- How to Use
- FAQ
CERESIT® IN 35 gypsum-based rendering skim coat is perfectly suitable for filling cracks, scratches and cavities on wall and ceiling surfaces. Thanks to InSure technology the material also enables to achieve smooth and durable surface which is suitable to be used under any types of paint coats. In addition, the material forms a solid and stable substrate for papering. Available pack size: 3 kg, 10 kg and 20 kg
-
Machine application possible
-
Easy to grind
-
Layer thickness up to 10 mm
-
Vapor permeable
-
With increased water retention
-
Good adhesion
CERESIT IN 35 can be applied on load-bearing substrates that are dry and free from grease, bitumen, dust, loose plaster grains and other substances decreasing adhesion.
The content of the package should be poured to a precisely measured amount of clean, cool water and stirred using a drill with a mixer until it forms a homogeneous mixture, free of lumps. Leave for approximately 5 min. and then stir the mixture again.
CERESIT IN 35 should be carefully applied – put-press it to fill the joint thoroughly. Then embed the tape (paper or fleece). If using paper tape, wet it before placing. When the first layer of IN 35 is already bound, apply a second, wider layer of the IN 35 skim coat. Do not use self-adhesive fiberglass mesh.
CERESIT IN 35 render skimming coat has excellent adhesion to gypsum substrates, plasterboards, aerated concrete, cement and cement-lime plasters.
CERESIT IN 35 is perfectly suitable for filling cracks, scratches and cavities on wall and ceiling surfaces.
Works should be carried out in dry conditions, with air and ground temperature ranging from +5 °C to +23 °C.