-
For indoor and outdoor use
-
Vapour permeable
-
High heat insulating features
-
Easily applied in layers up to 30 mm
-
Environmentally safe
CERESIT® CT 24 is used for preparing cell concrete blocs bases (gas or foam concrete). For finishing inside and outside buildings. Effective in repairing cracks, potholes, flutes and other defects on the surfaces. Thickness in one layer from 3 mm to 30 mm.Available pack size: 5 kg and 25 kg
The substrate must meet the requirements of SP 713330.2017, be dry, sufficiently strong and free from dust, efflorescence, limescale, grease, bitumen and other contaminants. Loose areas and delamination should delete.
The dry powder is gradually added to water with stirring, achieving a homogeneous mass without lumps. Mixing is done with a mixer or drill, with a stirring tip at a rotation speed of 400–800 rpm.
When work with material use traditional methods and tools. Do not grind the surface after smoothing! You can start tiling, levelling and applying decorative coatings no earlier than 3 days after applying the plaster, and for painting - not earlier than after 7 days. Fresh material residues can be removed with water, dried - only mechanical
Can be used for filling of cavities, chips and other defects of the cellular and lightweight concrete, old plasters and masonry, etc.
CERESIT CT 24 plaster mix is intended for repair, levelling and plastering of cellular concrete substrates (aerated concrete, aerated concrete, gas silicate, etc.), lightweight concrete, ceramic and silicate brick masonry, on walls inside and outside buildings, both with manual and mechanized application.
Works are to be executed at temperature of basis of +5 °C–+30 °C and air humidity not higher than 80%.