CERESIT® CT 127 plaster is designed for covering plastered surfaces and concrete surfaces, in a max. 2 mm layer. The surface covered with CERESIT CT 127 shall become perfectly smooth and immaculate white, so that it can represent the end finishing. Should you wish to do so the plaster coat may be painted after drying with dispersion paints and even with mineral support paints. This finish skim coat may be used indoors in dry areas free of permanent humidity. Available pack size: 20 kg
CERESIT CT 127 may be used on dry, dense, rough, clean surfaces which are free from anti-adhesive substances (fats, bitumen, dusts). See more details for the substrate preparation of the product in the Technical Data Sheet.
CERESIT CT 127 shall be introduced in the measured volume of clean, clear, cold water and shall be stirred by a paddle mixer until a uniform, lump free mass is obtained. The stirring shall be repeated after 10 minutes.
After being prepared, the plaster coat CERESIT CT 127 shall be applied in a uniform layer on the substrate, using the iron trowel. Layers applied on the wall and dried may be very easily finished by damping with water and smoothing with the iron trowel, thus achieving a very fine, almost shiny surface.
CERESIT CT 127 finish coat is used to cover the traditional renders, concrete surfaces and render CERESIT CT 126 in a maximum 2 mm layer thickness.
CERESIT CT 127 is used for obtaining smooth surfaces on walls and ceilings inside the buildings.
The work should be conducted in a dry environment, at an air and support temperature of +5 °C – +30 °C.