CERESIT CM 49 S2 PREMIUM FLEXIBLE

Features and Benefits

Special mega flexible white tile adhesive for demanding substrates

Properties

  • For large tiles and plates more than 120cm side length
  • Resistant to climate stresses on balconies, terraces and heated floors (S2 class)
  • On young/green screet
  • Can be used for Natural stone and marble

Read More

CM 29 Multi Xpress is used for the high-strength, void-free installation of ceramic tiles and slabs, both indoors and outdoors, using the thin-, medium- or thick-bed method (20mm). CM 29 Multi Xpress sets rapidly.

 

It can also be used for bonding large-tiles and slabs, and discoloration-proof installation of non-translucent natural stones.

Step by step

Substrate preparation

CM 14 EXPRESS adheres to all clean, solid, load-bearing, even, dry and moist substrates, which are free from substances which can reduce adhesion. Uneven areas or depressions should be levelled before (see Ceresit Flooring and Interior Finishes products). Coatings of insufficient load-bearing   strength must be removed. Gypsum/anhydrite or paint coats (not chalking, good adhesion) must be mechanically roughened and freed from dust.
Before applying CM 14 EXPRESS tile adhesive, check the residual moisture of the substrate! Absorbent substrates should be primed with Ceresit primer.
Please refer to the Technical Data sheet!

Mixing

Pour the content of the packaging into the measured amount of clean, cool water and mixe it with a drill mixer until a homogenous mass without lumps is obtained. It is necessary to wait for 5 minutes (maturing time) and then mix it once again. If necessary, carefully add water until the desired consistency is achieved.

Application

The adhesive should be applied with a suitable notched trowel, depending on the respective tile size. For indoor use, the mortar coverage (contact area) at the back of the tile must be at least 65 %. For outdoor use, a minimum mortar coverage of 90 % is required (combined laying method  should be used i.e. additionally apply a thin layer of the mortar on the tile backside).  CM 14 EXPRESS is fast setting - keep in mind the shortened skin formation time and pot life compared to normal setting tile adhesive.
Fresh excess mortar can be removed with water; hardened material can only mechanically be removed.
Use CM 14 EXPRESS only in dry conditions and at temperatures of +5 °C to +30 °C.