CERESIT CM 11 PLUS

Features and Benefits

Tile adhesive for indoor & outdoor (with limitations) applications of gres & ceramic tiles on wall & floor

Properties

  • For larger tiles up to 0.25 m² and 60 cm side-length
  • Extra ANTI-SLIP with larger tiles
  • Grouting on the wall after only 8h (gres tiles)
  • Low-emission certified ”EC1 PLUS®”
  • Easy mixing and spreading
  • For use on waterproofed surfaces
  • For indoor use, also in wet rooms, outdoor use possible in some cases (domestic area)
  • For gres and ceramic tiles

Read More

Ceresit CM 11 PLUS adhesive mortar is designed for laying gres and other ceramic, cement and natural stone tiles (colour-fast), indoors and outdoors. Thanks to a special combination of fillers, the new mortar CM 11 PLUS is easy to apply, therefore making the progress of works faster.

Step by step

Substrate preparation

CM 11 Plus adheres to all clean, solid, load-bearing, even, dry and moist substrates, which are free from substances which can reduce adhesion. Uneven areas or depressions should be levelled before (see Ceresit Flooring and Interior Finishes products). Coatings of insufficient load-bearing strength must be removed. Gypsum/anhydrite or paint coats (not chalking, good adhesion) must be mechanically roughened and freed from dust.
Before applying CM 11 Plus tile adhesive, check the residual moisture of the substrate! Absorbent substrates should be primed with Ceresit primer.

Please refer to the Technical Data sheet!

Mixing

Pour the content of the packaging into the measured amount of clean, cool water and mixe it with a drill mixer until a homogenous mass without lumps is obtained. It is necessary to wait for 5 minutes (maturing time) and then mix it once again. If necessary, carefully add water until the desired consistency is achieved.

Application

The adhesive should be applied with a suitable notched trowel, depending on the respective tile size. For indoor use, the mortar coverage (contact area) at the back of the tile must be at least 65 %. For outdoor use, a minimum mortar coverage of 90 % is required (combined laying method  should be used i.e. additionally apply a thin layer of the mortar on the tile backside). Fresh excess mortar can be removed with water; hardened material can only mechanically be removed.
Use CM 11 Plus only in dry conditions and at temperatures of +5 °C to +30 °C.