- For joint sealing (breathable impregnation)
- Suitable for use on absorbent and non-absorbent substrates
- For tiles, joints, natural stones, concrete & screeds
-
For joint sealing (breathable impregnation)
-
Suitable for use on absorbent and non-absorbent substrates
-
For tiles, joints, natural stones, concrete & screeds
-
Dirt-repellent and antifungal
-
Protects porous coverings
-
For indoor and outdoor use
CERESIT® CT 10 is used for impregnation of ceramic and concrete substrate, both on absorbent and non-absorbent substrates. It is ideal for terraces and balconies. Protects against water absorption on absorbent and damaged substrates, joints and tiles. CT 10 can be an additional sealer for substrates in bathrooms and showers. CT 10 is suitable for protection of bricks, clay products and absorbent natural stones, as it prevents moisture absorption.Available pack size: 1l, 3l
CERESIT CT 10 can be used on compact, clean, dry or slightly wet substrates. Any dirty or weak layer and the unevenness should be removed. The parts that are discolored or bloomed should be removed. Eliminate the possibility of moisture covering the substrate CT 10 on the side of the layer which should be impregnated.
The contents of CERESIT CT 10 package should be shaken well before use. Pour the material on the floor and apply it with the help of a rubber trowel or roller. Wait 5 minutes, remove excess material and wipe the substrate with a damp cloth. In case of impregnation of joints, the material is applied with a brush. The dried material can be removed with a solvent.
CERESIT CT 10 should be applied at a temperature of +5°C to +25°C and humidity below 80%. Do not use CT 10 on insulated and heated substrates. After about 2-6 h the impregnating agent becomes rain resistant. Full impregnation effect CT 10 is achieved after about 14 days.
CERESIT CT 10 is used for impregnation of ceramic and concrete substrate, both on absorbent and non-absorbent substrates. It is ideal for terraces and balconies. CT 10 can be an additional sealer for substrates in bathrooms and showers.
CERESIT CT 10 can be used on compact, clean, dry or slightly wet substrates. Any dirty or weak layer and the unevenness should be removed. CT 10 should not be used on insulated and heated substrates.
After about 2-6 h CERESIT CT 10 impregnating agent becomes rain resistant. Full impregnation effect CT 10 is achieved after about 14 days. A faster or slower drying of the basecoat can occur under various circumstances. CT 10 must not be poured into the sewage system. After the treatment, the room should be ventilated.