CERESIT® CT 80 is designed as an element of external thermal insulation composite CERESIT Ceretherm system of the building walls, using EPS, XPS or mineral wool. It is used as adhesive for EPS, XPS or mineral wool and for applying the reinforcing protection layer on insulation of newly constructed objects and older buildings to be thermo-renovated. CERESIT CT 80 thanks to Fibre Force Technology, strengthens the resistance of insulation system to damage, cracks and scratches. Available pack size: 25 kg
Fixing thermal insulation boards: CERESIT CT 80 mortar shows good adhesion to carrying, compact and dry substrates. Adhesion of CT 80 to the prepared substrate is checked by gluing 10 x 10 cm blocks of EPS-boards and pulling off after 4-7 days. Reinforced layer application: When CT 80 is bonded (after approx. 3 days), any unevenness of the boards should be grounded with abrasive paper, any loose particles of insulation materials carefully brushed and the boards additionally reinforced.
CERESIT CT 80 should be poured into water and stirred until the homogenous mass is obtained. Fixing thermal insulation boards: mortar should be applied and then the board should be pressed to the wall. Reinforced layer application: the glass fibre mesh should be applied on the fresh mortar and smoothed evenly. Fixing mineral wool boards: before application of adhesive mortar CT 80 it is necessary to apply thin coat of it as ‘priming’ of surface. 4. Reinforcing layer application: before proper base coat layer application, it is necessary to do the ‘priming’ layer on Mineral Wool surface. After drying time (24 hours), the reinforced layer should be applied.
The reinforced layer should not be applied on highly sunny surfaces and the applied layer should be protected against rain. Application should be performed in dry conditions with the substrate and ambient temperature from +5 °C to +25 °C. Skin and eyes should be protected. In case of contact with eyes, they should be rinsed with water and a general practitioner should be consulted.
CERESIT CT 80 mortar is designed as an element of external thermal insulation composite CERESIT Ceretherm system of the building walls, using EPS, XPS or facade mineral wool. It is used as adhesive for EPS, XPS or mineral wool and for applying the reinforcing protection layer on insulation of newly constructed objects as well as older buildings to be thermo-renovated.
CERESIT CT 80 can be applied on surfaces of walls, plasters, mosaics and concretes free from grease, bitumen, dust and other substances decreasing adhesion.
CERESIT CT 80 is present in CERESIT AQUASTATIC System, SELF CLEAN System, SOLAR PROTECT System, VISAGE System