CERESIT® CT 180 is designed to warm up external walls of the buildings by application of external thermal insulation composite system using mineral wool façade boards as well as lamella. It is an element of CERESIT Ceretherm WM Classic and WM Premium insulation systems. CT 180 is used for fixing of mineral wool façade boards to insulate the newly erected objects as well as the buildings to be thermo-renovated. it should be used in case of EPS-boards application used for insulating buildings. Available pack size: 25 kg
CERESIT CT 180 shows good adhesion to carrying, compact, dry and clean substrates free from substances decreasing adhesion of surfaces of walls, plasters and concretes. The adhesion to the existing plasters and paint coatings should be checked before starting the application. Any losses and uneven surfaces should be filled or covered. Any surface contaminant and other adhesion impairing substances, steam-tight paint coatings and the coats with low adhesion to the substrate should be removed.
CERESIT CT 180 should be poured into water and stirred until the homogenous mass is obtained without lumps. It is necessary to apply “priming” layer with CT 180 on MW bards before proper application of mortar, than on top of “priming”, right after ready mixed mortar should be applied along the board edges. Then immediately, the board should be pressed to the wall with a few slight blows of a long float.
Application should be performed in dry conditions with the substrate and ambient temperature from +5 °C to +25 °C. Skin and eyes should be protected. In case of contact with eyes, they should be rinsed with water and a general practitioner should be consulted.
CERESIT CT 180 mortar is designed to insulate external walls of the buildings by application of external thermal insulation composite system using mineral wool and also ceilings of buildings in garages. CT 180 mortar is used for fixing of mineral wool facade boards to insulate the newly erected objects as well as the buildings to be thermo- renovated.
CERESIT CT 180 can be applied on surfaces of walls, plasters and concretes.
CERESIT CT 180 is present in CERESIT Ceretherm AERO WOOL System