CERESIT® CT 29 is used for repair and levelling of cement-lime and cement-sand plasters, concrete and brickwork on walls and ceilings inside and outside of buildings. CERESIT CT 29 is used to fill deep hollows, cracks, sections of damaged bonding plaster and also for one layer levelling of surfaces and applying plaster with thickness of layer of maximum 20 mm, upon one passage. CERESIT CT 29 should not be used for repair of cement or concrete bases on floors.Available pack size: 25 kg.
Dirt and layers of low strength should be completely removed. The substrates of low absorption and non-homogeneous ones should be properly moistened with water. The substrate should be moist but not wet.
Mix with water until an homogeneous mass without lumps is obtained. The filler should be applied and smoothed with the metal long float. When the material becomes thicker it may be structured with the felt or Styrofoam long float.
CERESIT CT 29 should be mixed with a smaller amount of water to fill deep losses. One should apply the filler with the normal consistency to smooth the surface when the previously filled losses have dried.
Plaster filler CERESIT CT 29 is mainly used for repairing cement lime plasters inside and outside the buildings.
It may be applied both to fill deep losses (e. g. chases after installation work) and to smooth the plaster surface as well. The properties of CERESIT CT 29 make it possible to apply thin “putties” on the walls and ceilings, to cover rough and uneven cement and cement-lime plaster surfaces.
Application should be performed in dry conditions with the substrate and ambient temperature from +5 °C to +25 °C. All the data refer to the temperature of +20 °C and relative air humidity of 65 %.