-
Good adhesion
-
Water-repellent and weather-resistant
-
Vapour-permeable (breathable)
-
Reinforced with microfibres
-
Flexible
-
Easy-to-apply
CERESIT® CT 34 is used to make smooth surfaces on reinforced layers in complex CERESIT Ceretherm thermal insulation systems. The material can also be used to repair traditional cement-lime plasters inside and outside buildings. CT 34 makes thin-layer smooth surfaces on walls and ceilings, completely covering uneven and rough surfaces of reinforced layers, cement plasters and cement-lime plasters. The thickness of the total plaster layer should be up to 5 mm. Available pack size: 25 kg
CERESIT CT 34 can be applied to substrates that are even, load-bearing, dry and free from grease, bitumen, dust and other substances that reduce adhesion. It is recommended to prime dry and very absorbent substrates, especially walls made of aerated concrete blocks and silicate blocks with CERESIT CT 17. Then a reinforced layer should be made. Substrates may be additionally painted with CERESIT CT 16 quartz primer.
Put the contents of the pack into a measured quantity of water and mix until a homogeneous mass without lumps is obtained. Apply the plaster onto the prepared substrate with a metal float. After the material has set, i.e. after about 90 minutes, it should be trowelled with a sponge float. The maximum thickness of the plaster layer is 5 mm. After complete drying, i.e. after about 24 hours, the plaster may be painted.
The work should be carried out in dry conditions, with an air temperature and substrate temperature ranging from +5°C to +25°C. It is necessary to protect your skin and eyes. If the material comes into contact with your eyes, rinse them thoroughly with water and seek medical advice.
CERESIT CT 34 is used to create smooth surfaces on reinforced layers in complex CERESIT thermal insulation systems Ceretherm. The material can also be used to repair traditional cement-lime plaster inside and outside buildings.
CERESIT CT 34 can be applied on walls and ceilings thin layer smooth surfaces, on reinforced layers, cement and cement-lime plasters.
CERESIT CT 34 is present in CERESIT Ceretherm AERO WOOL System