Renovation plasters
CERESIT CR 64
SMOOTHING PLASTER 'OFF WHITE'
Finishing layer of the renovation façade system
-
Hydrophobic and water vapour permeable
-
Creates uniform surface on plasters of various textures
-
Easily workable and feltable
- Description
- How to Use
- FAQ
CERESIT® CR 64 is used as a finishing layer of the renovation system inside and outside of the buildings. It allows to make skim coats on walls and ceilings, completely covering uneven and rough surfaces of renovation plaster, traditional cement and cement-lime plasters. The addition of trass powder ensures good working properties and reduces the possibility of salt efflorescence. CR 64 can be used to fill cornices, drawn profiles, stucco profiles and decorative elements. Available pack size: 25 kg
-
Hydrophobic and water vapour permeable
-
Creates uniform surface on plasters of various textures
-
Easily workable and feltable
-
Very good adhesion to mineral substrates
-
For indoor and outdoor use
-
Contains trass
CERESIT CR 64 adheres to all solid, load-bearing, clean, dry and damp substrates, free of substances that may impair adhesion. Any dirt and layers of weak strength must be completely removed, as well as anti-adhesive substances and paint coatings. Pre-wet brickwork until the surface is no longer absorbent and appears to be slightly dump. Very dry and highly absorbent substrates prime with CT17 deeply penetrating primer and wait for drying minimum 2 hours. Non-absorbent, very smooth surfaces should be primed with CT 19 contact primer before applying CR 64.
Pour the material into a pot with measured amount of approx. 6 l clean, cool water and mix with a low speed mixer until a homogeneous mass without lumps is obtained. After stirring leave material for 5 minutes maturing time and stir briefly again. The plaster prepared in this way should be used within 2 hours. The addition of water depends on the required consistency.
Use CR 64 only in dry conditions and at temperatures of +5°C to +30°C and below 80% relative humidity. Do not mix with other materials, additives or binders. Do not use on gypsum-based substrates or cover with gypsum-based products. All data given was obtained at an ambient and material temperature of +20°C and 65% relative humidity unless specified otherwise. Protect skin and eyes. For professional users.
CERESIT CR 64 is used inside and outside of the buildings. It can be used to fill cornices, drawn profiles, stucco profiles and decorative elements.
CERESIT CR 64 is used inside and outside of the buildings. It can be used to fill cornices, drawn profiles, stucco profiles and decorative elements.
CERESIT CR 64 is used inside and outside of the buildings. It can be used to fill cornices, drawn profiles, stucco profiles and decorative elements.