Adhesive mortars
CERESIT CT 83
STRONG FIX
Mortar for fixing Expanded Polystyrene (EPS) boards for thermal insulation of buildings in ETICS systems.
-
High adhesion to mineral substrates and EPS-boards
-
Very good working parameters
-
Weather conditions resistant
- Description
- How to Use
- FAQ
CERESIT® CT 83 mortar is designed to apply EPS-boards within CERESIT ETICS with a light-wet method CERESIT Ceretherm. CT 83 mortar is used for applying to the newly erected objects as well as the buildings to be thermo renovated. The applied boards require additional fixing by means of mechanical anchors, i.e. proper expansion pins made of plastic. CERESIT CT 85, CT 87 or CT 100 mortar should be used to apply fibre glass armoured layer on the EPS-boards. Available pack size: 25 kg
-
High adhesion to mineral substrates and EPS-boards
-
Very good working parameters
-
Weather conditions resistant
-
Possibility of machine application
CERESIT CT 83 shows very good adhesion to sound and carrying substrates, such as wall, plaster and cement substrates free from grease, bitumen, dust and other substances decreasing adhesion. The adhesion to the existing plasters and paint coatings should be checked before starting the application. Any surface contaminant and other adhesion impairing substances, steam-tight paint coatings and the coats with low adhesion to the substrate should be completely removed.
CERESIT CT 83 should be poured into water and stirred with the drill by means of a mixer until the homogenous mass is obtained. The ready mortar should be applied with a trowel along the board edges. Then immediately, the board should be pressed to the wall. When CT 83 is set (after approx. 3 days), any unevenness of the boards should be ground with abrasive paper, then the boards should be additionally reinforced with mechanical anchors.
CERESIT CT 83 powder mortar shows acrid properties, and cement and lime content causes alkali reaction when mixed with water. Skin and eyes should be protected. In case of contact with eyes, they should be rinsed with water and a general practitioner should be consulted.
CERESIT CT 83 mortar is designed to apply EPS and XPS-boards within CERESIT ETICS (External Thermal Insulation Composite Systems) with a light-wet method CERESIT Ceretherm. It is used for applying to the newly erected objects as well as the buildings to be thermo-renovated.
CERESIT CT 83 mortar is designed to apply EPS and XPS-boards within CERESIT ETICS (External Thermal Insulation Composite Systems) with a light-wet method CERESIT Ceretherm. It is used for applying to the newly erected objects as well as the buildings to be thermo-renovated.
CERESIT CT 83 mortar is designed to apply EPS and XPS-boards within CERESIT ETICS (External Thermal Insulation Composite Systems) with a light-wet method CERESIT Ceretherm. It is used for applying to the newly erected objects as well as the buildings to be thermo-renovated.