Wet plasters (finishes)
CERESIT CT 760 VISAGE
ARCHITECTURAL CONCRETE
With the texture of architectural concrete for decorative facade coatings in ETICS for outdoor and indoor use.
-
Thin-layer and flexible
-
Resistant to scratches and damages
-
Resistant to weather conditions
- Description
- How to Use
- FAQ
CERESIT® CT 760 Visage plaster is used for creating thin-layer decorative coatings on building facades, with the effect of architectural concrete. CT 760 as a facade plaster is one of the components used in the external thermal insulation composite CERESIT Ceretherm system for building walls (ETICS) with application of expanded polystyrene boards. Available pack size: 25 kg.
-
Thin-layer and flexible
-
Resistant to scratches and damages
-
Resistant to weather conditions
-
Ready-to-use
-
Wide range of possible structures and application techniques
-
Available in three shades of grey
CERESIT CT 760 plaster can be applied on even and load-bearing substrates that are dry and free from grease, bitumen, dust, loose plaster grains and other substances decreasing adhesion. When used in ETICS systems, the mesh base coat for application of CT 760 plaster should be prepared. Uneven and damaged substrates shall be smoothed and repaired before the application of the product. CT 60 can be applied after min. 12 hours when the CT 16 primer layer has dried out completely.
CERESIT CT 760 plaster is ready-to-use. After opening, the content of the package shall be thoroughly mixed using a mixing paddle. It is recommended to apply CT 760 plaster in two layers. The base coat can be applied by means of a stainless steel coat, while the textural layer – with a high-quality stainless steel fl oat with rounded corners. The variety of techniques and textures depend on the desired final effect and the experience in application.
Application should be performed in dry conditions, with the air and substrate temperature from +10 °C to +25 °C and at relative air humidity below 80 %. The material shall not be applied in windy conditions since this may cause too rapid drying during application. The product should not be mixed with other plasters, dyes, resins or other binders.
CERESIT CT 760 VISAGE plaster is used for creating thin-layer decorative coatings on building facades, with the effect of architectural concrete. As a facade plaster, it is one of the components used in the external thermal insulation composite CERESIT Ceretherm system for building walls (ETICS) with application of expanded polystyrene boards. Different techniques of application and surface finish can produce the effects of raw architectural concrete of various forms, e.g. formwork, honeycombing, pitting, etc.
CERESIT CT 760 VISAGE plaster is used for creating thin-layer decorative coatings on building facades, with the effect of architectural concrete. As a facade plaster, it is one of the components used in the external thermal insulation composite CERESIT Ceretherm system for building walls (ETICS) with application of expanded polystyrene boards. Different techniques of application and surface finish can produce the effects of raw architectural concrete of various forms, e.g. formwork, honeycombing, pitting, etc.
CERESIT CT 760 VISAGE plaster is used for creating thin-layer decorative coatings on building facades, with the effect of architectural concrete. As a facade plaster, it is one of the components used in the external thermal insulation composite CERESIT Ceretherm system for building walls (ETICS) with application of expanded polystyrene boards. Different techniques of application and surface finish can produce the effects of raw architectural concrete of various forms, e.g. formwork, honeycombing, pitting, etc.