-
Perfectly smooth
-
Long working time
-
Easy to apply
-
Suitable for wet areas
-
Frost resistant
-
For non-absorbent tiles and mosaic
CERESIT® CE 33 is a perfect solution for filling wide and narrow tile joints from 1 up to 8 mm. Recommended for indoor and outdoor use, CE 33 is easy applicable and a colour stable grout with high crack resistance. CE 33 is improved with MC-Polymers and suitable for smooth surface finish in wet areas. Available in 22 brilliant colours and ready to use after 24 hours.Available pack size: 5 kg, 25 kg
The surface and thin-bed mortar, dispersion adhesive or thick-bed mortar must have set sufficiently hard and dry. Before applying CERESIT CE 33 scraped joints must first be wetted. In case of tile coverings with a porous or non-scratchproof surface test suitability of CE 33 for grouting.
Mix CERESIT CE 33 with 0.5L to 15L of cold and clean water using an electric mixer until you obtain a homogenous mixture. Mix again after 3 minutes.
Fill the joints with CERESIT CE 33 using a special grout float or rubber squeegee, without leaving any gaps. Wipe over and clean freshly grouted tiles with a damp sponge. Remove the dry film with a soft cloth. Damp freshly grouted joints after 24 hours to prevent surface moisture deficiency. Floor tiles can be walked on after only 24 hours.
CERESIT CE 33 is recommended for indoor and outdoor use, in wet areas, for a smooth surface finish on the tiles. CE 33 is used for filling joints in floor & wall of ceramic, porcelain, mosaic, natural stone, marble and granite indoor and outdoor areas as balcony, low height cladding. Use CE 33 for narrow and wide joints of 1 to 8 mm.
When applying CERESIT CE 33 between 1 and 2mm always assure that the joint will get cured with water for at least 24 hours. When using different packs of joint mortar, the colour may vary slightly. Therefore make sure to use bags of the same batch number within a building or room.
Use CERESIT CE 33 only in dry conditions and at temperatures of +5°C to +40°C.